Why was Teredo disabled?

Started by Alex

Alex

Why was Teredo disabled? 08 December 2013, 15:52

I installed Networx on two Win7 computers, one is 32-bit and the other is 64-bit. After install both computers showed a yellow sign near Teredo Tunneling Pseudo-Interface in Device Manager. "This device cannot start. (Code 10)".
I re-enabled Teredo in the registry and it works normally again, but I was wondering why would you need to disable it in the first place? Thanks.

Reply Quote

Andrew

Re: Why was Teredo disabled? 08 December 2013, 16:09

Admin
Registered: 12 years ago
Posts: 5 643

This is a workaround when the WFP (Windows Filtering Platform) driver is installed. If you choose to install the TDI driver, Teredo will stay enabled.

Reply Quote

Alex

Re: Why was Teredo disabled? 09 December 2013, 09:44

Hi Andrew,

Where can I find more information about this problem/workaround?
I manually enabled Teredo in the registry, so what happens now?
Is WFD totally incompatible with Teredo? Thanks.

Reply Quote

Andrew

Re: Why was Teredo disabled? 09 December 2013, 11:08

Admin
Registered: 12 years ago
Posts: 5 643

I am not sure, as this is what the installation procedure of the traffic filtering driver does.

This is a third-party driver and they say Teredo may be disabled for the installation of a WFP driver, which is then re-enabled after a reboot.

I suppose if it's working fine for you, you don't need to do anything.

Reply Quote

Alex

Re: Why was Teredo disabled? 09 December 2013, 14:17

Quote
...which is then re-enabled after a reboot

OK, now I see. Basically mine did not get re-enabled, so I enabled it manually. Otherwise everything seems to work fine. Thanks for clarifications.

Reply Quote

Hussin

How to re-enable Teredo manually 03 July 2018, 13:33

If anyone still checks this page: how exactly can I re-enable Teredo manually?

Reply Quote

Andrew

Re: How to re-enable Teredo manually 03 July 2018, 16:03

Admin
Registered: 12 years ago
Posts: 5 643

Perhaps this can help? In an admin command prompt type:

netsh interface teredo set state type=default

Reply Quote

Newer topic Older topic

Print view of this page

Sometimes you can get the answer faster if you try the forum search and/or have a look at the software user manual to see if your question has already been answered.

Our forum rules are simple:

Be polite.
Do not spam.
If possible, check your spelling and grammar.

Author:

Email:

Subject

A brief and informative title for your message, approximately 4–8 words:

Disable BBcode in this message Disable smileys in this message

Help information

Spam prevention: please enter the following code in the input field below.

       **  **      **  **     **   *******   ********  
       **  **  **  **  **     **  **     **  **     ** 
       **  **  **  **  **     **  **         **     ** 
       **  **  **  **  *********  ********   ********  
 **    **  **  **  **  **     **  **     **  **        
 **    **  **  **  **  **     **  **     **  **        
  ******    ***  ***   **     **   *******   **

Enter the code:

Message:

Why was Teredo disabled?

Software Products

Store & Support

Download

SoftPerfect